Home
Orin Nano/NX Carrier BoardXavier NX Carrier BoardJetson Nano Carrier BoardGoogle Coral Base Board
FCB-ER9500FCB-ER8530FCB-EV9520LFCB-EV9500LFCB-EW9500HFCB-EV9500M
LVDS – MIPIHDMI – MIPIPAL – MIPIMIPI – Adaptor
HDMI InterfacePAL InterfaceUSB Interface
Touch Screen ControlKeypad ControlRemote Control
NVIDIANXPRockchipQualcommTexas InstrumentsRenesasRaspberry PiTurnkey Drivers
Wireless 4K CameraWired 4K Camera
O-MoteO-RouterMQTT Software
Wireless Video & TelemetryPower Distribution ModuleCube Power Module
3.3V Single Apex Dev Kit3.3V Quad Apex Dev kitFPAA Trainer – Real GNA
AI SolutionBSP & Camera DriverOn-Premise CloudCustom Design
Artificial IntelligenceInternet of Things
DocsBlogGallery
Contact UsGlobal Network

Raspberry Pi 5 Image Bringup

This guide provides step-by-step instructions for setting up the Oppila integration package on a Raspberry Pi running the 64-bit Trixie (Debian 13) operating system. This configuration is required to establish a connection between the Raspberry Pi and the LVDS–MIPI CSI-2 Bridge Board for video streaming.

The primary purpose of this procedure is to flash, configure, and initialize the Raspberry Pi with the OPPILA_RASP_TRIXIE_64_INTEGRATION package to enable seamless video streaming.

This procedure applies specifically to Raspberry Pi devices running the 64-bit Trixie (Debian 13) image, configured with the OPPILA_RASP_TRIXIE_64_INTEGRATION package, and connected to the bridge board using its assigned serial number.

System Architecture

System Architecture

1
Host PC OS Flashing

Host PC running Raspberry Pi Imager application flashes the 64-bit Trixie (Debian 13) OS image onto a MicroSD card.

2
LVDS video capture

Sony EV9520L outputs raw video over the LVDS interface to the bridge board.

3
Protocol conversion

Bridge board converts LVDS to MIPI CSI-2 and streams it to the Raspberry Pi 5.

4
GStreamer pipeline

Raspberry Pi 5 initializes the CSI bridge camera interface using the OPPILA_RASP_TRIXIE_13_INTEGRATION package, and GStreamer reads and renders the video output.

Prerequisites

Before beginning this procedure, ensure the following requirements are met:

Host
Host PC
with required Raspberry Pi Imager application installed
Hardware Components
Raspberry Pi
Raspberry Pi device with compatible hardware
LVDS-MIPI CSI-2 Bridge Board
Bridge board with a valid serial number
Resources
MicroSD Card
MicroSD card with sufficient storage capacity (e.g., 64GB)
Network Connection
Active network connection for the Raspberry Pi
Required Files

Note

These files are not publicly available. Contact Oppila Support Team for the files.

OPPILA_RASP_TRIXIE_64_INTEGRATION.zip
Pre-built Raspberry Pi OS Image archive.